Twïnlux - Invicon TwinLux Mode D'emploi

Stand (6)
The integrated stand (6) is used to position the light source at an appropriate distance
to the polymerization surface during the curing procedure.
On/off and timer switch (7)
The LED light source (5) is switched on and off by means of the on/off and timer switch
(7). The individual curing times are chosen by applying varying degrees of pressure to
the on/off and timer switch. As soon as the on/off switch is pressed down and the LED
source starts emitting light, the curing time indicator (11) lights up or starts blinking.
Light protection shield (8)
The light protection shield prevents uncontrolled light emission from the
LED source (5).
9
10
10
11
11
LED indicators
9
9 Power on indicator
10 Battery charge indicator
11 Curing time indicator
Power on indicator (9)
The red light emitting LED (9) on the rear of the light shows whether the unit is
connected to the power supply:
Power supply
LED is off
Continuously illuminated
Battery charge indicator (10)
The red light emitting LED (10) on top of the light shows the amount of power left in
the battery (see also Section 3.2).
i
NOTE!
Exact indication of the amount of power left
You are given a more precise indication of the amount of power left in the battery
after having carried out two to three curing cycles.
Curing time indicator (11)
The green light emitting LED (11) on top of the unit shows which curing setting has
been selected. The unit switches off automatically after the curing time has elapsed
(except for continuous operation).
Curing time indicator (11)
Fast blinking
Slow blinking
Continuously illuminated
TwinLux m3
No power supply No power supply
Battery is being Battery is being
charged with power charged with power
TwinLux m3
30 seconds –
60 seconds 180 seconds
Continuous light Continuous light
7
7