Operation; Carrying Out Light-Curing Cycles - Invicon TwinLux Mode D'emploi

4 Operation

WARNING!
Light emission of LED source
Direct exposure to the light of the LED light source may cause damage to the eyes.
> Do not look directly into the LED light source.
> Use the light unit only with a properly mounted and fully functioning
light protection shield.
> Always make sure that the light protection shield is mounted properly.
> Do not point the light beam of the LED source directly into the eyes.
> Always direct the light beam of the LED light source towards the surface
to be polymerized.
WARNING!
Defective device
Malfunctioning devices or components may cause injury.
> Before each use, check the device for the following:
– The device and its accompanying components are in proper working condition.
– The light protection shield is correctly mounted on the light unit.
– The air vents are free of obstruction.
10
10

4.1 Carrying out light-curing cycles

5
7
5
7
8
8
Light emission
5 LED light source
7 On/off and timer switch
8 Light protection shield
TwinLux
> Mount the light protection shield (8) over the LED light source (5).
> Select the desired curing time by pressing the on/off and timer switch (7) as follows:
On/off switch (7) Curing time
Short touch (< 1 sec) 30 seconds
Short pressure (approx. 2 sec) 60 seconds
Sustained pressure (> 2 sec) Continuous light emission Continuously illuminated
> To interrupt or stop the curing cycle, press again on the on/off switch (7).
7
7
8
8
Curing time indicator (11)
Fast blinking
Slow blinking