User Interface; Main Template - AERMEC ANKI 020 Manuel D'utilisation

USER INTERFACE

The pLDPRO graphic display unit is an electronic device for complete graphics management through icons and the management of international 2D fonts:
6x8 & 12x16 pixels and a buzzer-activated acoustic signal. The application software is only resident on the pCO card; the terminal needs no additional soft-
ware when in use. Moreover, the terminal offers a broad range of operating temperatures and the frontage ensures a high level of protection (IP65).
Press once: Display the alarm of the alarm chronology
Alarm Button:
Press for 3 sec: Reset
Menu Button
Esc button

MAIN TEMPLATE

10
8
7
5
11
6
9
12
4
FL
2 1
3
Enter Button:
CONTROL PANEL ON-BOARD MACHINE
1 ON/OFF
2 Pump ON
3 FL
4 Antifreeze heater
5 Inverter percentage power bar
6 Season
7 Set
8 Temperature
9 Current date and time
10 Alarm Active
11 ForceOff Active
12 Hourly bands active
Scrolling button:
- Navigation and changing parameters
Press once:
- Go to menu
- Go to parameter
- Confirm parameter
Press for 3 sec:
- Machine On/Off
Scrolling button:
- Navigation and changing parameters
Indicates the on/off status set by the
user through the display (does not take
account of the BMS supervisor or remote
digital contact)
Indicates pump status
Indicates that there is no flow of water
Indicates antifreeze heater status
Graphically indicates compressor per-
centage power
Running mode
Current setpoint used. Includes any cor-
rections bases on outside air if activated
Temperature at which adjustment is
made (Output of Input)
Indices the presence of one or more
alarms
Indicates that the force off threshold has
been reached or the low water content
algorithm is active
Indicates that hourly bands are enabled
5