Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Important safety information
INSTALLATION SAFETY
WARNING
To reduce the risk of fire, electric shock, personal injuries, and/or death, obey the
following precautions.
•
Do not attempt to service, modify, or replace your range or any part of your
range unless it is specifically recommended in this manual. All other service
should be referred to a qualified technician.
•
Always use new flexible connectors when installing a gas appliance. Do not
use old flexible connectors.
•
Make sure the anti-tip device is properly installed on the range. See the
installation instructions for more information.
•
Due to the size and weight of the range, have two or more people move the
range.
•
Remove all tape and packaging materials.
•
Remove all accessories from the cooktop, oven, and/or lower drawer. Grates
and griddles are heavy. Use caution when handling them.
•
Make sure no parts came loose during shipping.
•
Make sure your range is correctly installed and adjusted by a qualified service
technician or installer for the type of gas (natural or LP) you will use. For
your range to utilize LP gas, the installer must replace the 5 surface burner
orifices and 2 oven orifices with the provided LP orifice set, and reverse
the GPR adapter. These adjustments must be made by a qualified service
technician in accordance with the manufacturer's instructions and all codes
and requirements of the authority having jurisdiction. The qualified agency
performing this work assumes the gas conversion responsibility.
6 English
Install_NY63T8751S_DG68-01305A-01_EN+CFR.indb 6
•
Have your range installed and properly
grounded by a qualified installer,
in accordance with the installation
instructions. Any adjustment and
service should be performed only by
qualified gas range installers or service
technicians.
•
Installation of this range must conform with local codes or, in the absence of
local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA.54, latest
edition. In Canada, installation must conform with the current Natural Gas
Installation Code, CAN/CGA-B149.1, or the current Propane Installation Code,
CAN/CGA-B149.2, and with local codes where applicable. This range has been
design-certified by ETL according to ANSI Z21.1, latest edition, and Canadian
Gas Association according to CAN/CGA-1.1, latest edition.
LOCATION SAFETY
WARNING
To reduce the risk of fire, electric shock, personal injuries, and/or death, obey the
following precautions.
•
Select a level, well-constructed floor that can support the range's weight.
Synthetic flooring, such as linoleum, must withstand 180 °F (82 °C)
temperatures without shrinking, warping, or discoloring. Do not install
the range directly over interior kitchen carpeting unless a sheet of ¼ inch
plywood or a similar insulator is placed between the range and carpeting.
•
Select a location where a grounded, 3- prong outlet is easily accessible.
•
If the range is located near a window, do not hang long curtains or paper
blinds on that window.
•
For the range to ventilate properly, make sure the range's vents are not
blocked or covered, and that there is enough clearance at the top, back, sides,
and underneath the range. The vents allow the necessary exhaust for the range
to operate properly with correct combustion and get the good cooking result.
•
Make sure the wall coverings around the range can withstand heat up to
194 °F (90 °C) generated by the range.
•
This range is for indoor, household use
only. Do not install the range in areas
exposed to the weather and/or water.
•
Do not install the range in a place
which is exposed to a strong draft.
2020-07-20
4:47:21
Publicité
Table des Matières
