Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installing a 4-wire power cord
WARNING
The neutral wire of the supply circuit must be connected to the neutral terminal
located in the lower center of the terminal block. The power leads must be
connected to the lower left and the lower right terminals of the terminal block. The
4th grounding lead must be connected to the frame of the range with the ground
plate and the ground screw.
Ground strap
Ground plate
Neutral
White
terminal
Black
Red
White
Black
Red
Ground wire
Ground
(Green)
screw
Install_NY63T8751S_DG68-01305A-01_EN+CFR.indb 19
Remove the 3 lower terminal screws
1.
from the terminal block. Remove the
ground screw and ground plate and
retain them.
2.
Cut and discard the ground strap. Do
not discard any screws.
3.
Insert the one ground screw into the
power cord ground wire terminal ring,
through the ground plate, and into the
frame of the range.
4.
Insert the 3 terminal screws (removed
earlier) through each power cord
terminal ring and into the lower
terminals of the terminal block. Be
certain that the center wire (white/
neutral) is connected to the center
lower position of the terminal block.
Tighten screws securely into the
terminal block.
5.
Go to step 6 on page 21 and proceed
with the installation.
Step 5. Installing the conduit
Remove the conduit connection plate from the rear of the drawer body and rotate
it as shown below.
The conduit hole (1⅛") must be used.
1.
Prepare the conduit cord shown in Figure 1.
2.
Install the conduit cord as shown in Figure 2.
Figure 1
1"
⅜"
1"
⅜"
3½"
3½"
3 wire
4 wire
Knockout surface
Conduit connection plate
For conduit installations, insert the strain relief (not included) into the conduit hole
(1⅛"). Then thread the conduit cord through the body of the strain relief and fasten
the ring. Reinstall the bracket.
1⅛"
1⅜"
1⅜"
1⅛"
Figure 2
Ring
Body
Strain relief
English 19
2020-07-20
4:47:34
Publicité
Table des Matières
