Publicité
Instructies Instructions Conseils de montage Einbauanleitung Upute za montažu
EN
First decide where you want to put your LoooX Colour BoX.
It is important to assess in advance how deep the BoX can or needs to be placed as installation
depth is variable. The maximum incorporation of this recess is 10cm, but the Colour BoX can
extend out a little.
Located at the rear of your LoooX Colour BoX are one or two screwed tubes to which the fixing
clamp can be screwed on to. Using this clamp you can simply fix your LoooX Colour BoX in a
place that suits you. Before assembling stick the supplied self-adhesive bonding strip, it can be
useful for securing the BoX in place when for example using quick drying cement.
Set your LoooX Colour BoX with for example wedges, quick drying cement and the supplied
clamps. Once levelled off use masking tape (and old newspapers if necessary) to protect the
BoX.
Once you have protected the LoooX Colour BoX, the wall can be tiled. Make sure you tile as
closely as possible around your Colour BoX. We recommend an area of 3mm around your
Colour BoX; this is to allow room for sealant. Your Colour BoX must always be sealed! For the
best adhesion, degreasing of your product is essential.
Your LoooX Colour BoX is excellently suited to your bathroom, even in the wet area.
Damage claims on assembled LoooX Colour Boxes will be rejected.
Tip: Place your LoooX Colour Box level with a join so that less cutting of tiles is needed.
Warning: Small imperfections may be seen on sprayed products. These
imperfections cannot be claimed against. It is not recommended to place products
with corrosive steel or aluminum bottoms directly on the stainless steel
COLOUR BOX
9
Publicité
