Samsung POWERbot SR1 M70 Serie Guide De Référence Rapide page 5

2
WARNING
Power related
• Please prevent any risk of electric shock
or fire.
– Do not damage the power cord.
– Do not pull the power cord too hard or
touch the power plug with wet hands.
– Do not use a power source other than
100-240 V~ and also do not use a
multi outlet to supply power to number
of devices at the same time. (Do not
leave the cord carelessly on the floor.)
– Do not use a damaged power plug,
power cord or loose power outlet.
• Clean dust or any foreign matters on the
pin and contact part of the power plug.
– There is a risk of electric shock or
malfunction.
Before use
• Do not use POWERbot near combustible
materials.
– Place near candle, desktop lamps,
fireplace or near combustible materials
such as gasoline, alcohol, thinners etc.
• The POWERbot is intended for household
use therefore do not use it in an attic,
basement, storage, industrial building,
out of indoor space, places with moisture
(such as bathroom, laundry), on the table
or shelves.
– The POWERbot can be damaged or
malfunction.
• Be sure POWERbot does not pass
through or touch any kind of liquids.
– The POWERbot can be severely
damaged and it may contaminate other
areas if the wheels pass through liquid.
• Do not spill any liquids on the docking
station.
– There is a risk of fire or electric shock.
-3
Safety information
English-5
• Do not use the docking station for
anything other than its intended
purpose.
– There is a risk of fire or severe damage
to the docking station.
• Always keep the cliff sensor clean for
your safety.
In use
• If any abnormal sounds, smells or smoke
come from POWERbot, immediately shut
off the emergency switch at the bottom
of POWERbot and contact a service
center.
Cleaning and maintenance
• When power cord is damaged, contact
a service center to get it replaced by a
certified repairman.
– There is a risk of fire or electric shock.
• Please check with a Samsung Electronics
service center when exchanging
batteries.
– Using batteries from other products
can cause malfunction.