Axis Communications Q60 Serie Guide D'installation page 19

• To install the product using the hard ceiling mount, see page 19.
• To install the product using the drop ceiling mount, see page 21.
• To install the product using a compatible bracket from AXIS T91A Mounting Accessories
(sold separately), see page 23.
• To install the supplied midspan, see page 25.
Replace the Dome Cover
Replacing the dome cover is only necessary if you want to use the smoked dome cover or if the
dome cover is scratched or damaged. Spare dome covers can be purchased from your Axis reseller
1. Loosen the dome ring screws and remove the dome cover.
2. Remove the dome bracket screws and remove the dome bracket and the dome cover
from the dome ring.
3. Attach the dome bracket and the dome cover to the dome ring and tighten the screws
(torque 1.2 Nm).
4. To install an SD card (not included), see Install an SD Card on page 19.
5. Attach the dome cover to the top cover and tighten the screws (torque 1.5 Nm).
Install an SD Card
It is optional to install a standard or high capacity SD card (not included), which can be used for
local recording with removable storage.
1. Loosen the dome ring screws and remove the dome cover.
2. Insert an SD card (not included) into the SD card slot.
3. Attach the dome cover to the top cover and tighten the screws (torque 1.5 Nm).
NO NO TICE NO TICE TICE
To prevent corruption of recordings, the SD card should be unmounted before it is ejected.
To unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
Hard Ceiling Mount
1. Prepare the ceiling for installation of the mounting plate. The supplied drill template
can be used to position the holes. Make sure to use drill bits, screws and plugs that
are appropriate for the material.
2. Install the mounting plate. The arrow on the mounting plate will align with the logotype
on the camera.
AXIS Q60 Series
19