Important Precautions For The Installer; Declaration Of Conformity - AS Torantriebe R50 24V Notice D'emploi Et D'installation

IMPORTANT PRECAUTIONS FOR THE
INSTALLER
For any installation problems please contact V2 S.p.A.
TEL. (+39) 01 72 81 24 11
V2 S.p.A. has the right to modify the product without previous
notice; it also declines any responsibility to damage or injury
to people or things caused by improper use or wrong
installation.
Please read this instruction manual very carefully
before installing and programming your control unit.
• This instruction manual is only for qualified technicians, who
specialize in installations and automations.
• The contents of this instruction manual do not concern the
end user.
• Every programming and/or every maintenance service should
be done only by qualified technicians.
AUTOMATION MUST BE IMPLEMENTED IN COMPLIANCE WITH
THE EUROPEAN REGULATIONS IN FORCE:
EN 60204-1 (Machinery safety electrical equipment of
machines, part 1: general rules)
EN 12445 (Safe use of automated locking devices, test
methods)
EN 12453 (Safe use of automated locking devices,
requirements)
• The installer must provide for a device (es. magnetotermical
switch) ensuring the omnipolar sectioning of the equipment
from the power supply. The standards require a separation of
the contacts of at least 3 mm in each pole (EN 60335-1).
• Installation requires mechanical and electrical skills,
therefore it shall be carried out by qualified personnel only,
who can issue the Compliance Certificate concerning the
whole installation (Machine Directive 98/37/EEC, Annex IIA).
• Also the automation upstream electric system shall comply
with the laws and rules in force and be carried out
workmanlike.
• Verification of thrust force and inversion times, in the case of
the detection of a door leaf obstacle, must satisfy the
minimum requirements indicated in standard EN 12453.
• For correct installation of the system, we recommend
following the instructions issued by UNAC very carefully,
which can be consulted at the following web site:
www.v2home.com
• The appliance is not to be used by children or persons with
reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given
supervision or instruction.
• Children being supervised do not play with the appliance
• The supply cord cannot be replaced. If the cord is damaged
the appliance sholud be scrapped.

DECLARATION OF CONFORMITY

V2 S.p.A. declares that the series of VULCAN actuators are in
conformity with the provisions of the following EC directives:
2006/95/CEE electrical safety
93/68/CEE electromagnetic compatibility
98/37/CEE machine directive
Note: Declares that the above mentioned devices may not be
operated until the machine (automated gate) is identified, CE-
labeled, and declared to be compliant to the specifications of
Directive 89/392/EEC and following modifications.
The installation supervisor must provide the user with copies of
the following documents:
• Technical specification paper
• Declaration of conformity
• CE-labeling
• Testing record
• Maintenance record
• Operation manual and directions
Racconigi 04/05/2007
V2 S.p.A. legal representative
A. Livio Costamagna
7