ATOMSTACK A5 Mode D'emploi page 8

Tick mark font
direction
The hole side faces
outward
S t e p 1
Y
X
Step1 Required components:
Installation Manual:
1. Find the four large profiles in the picture
above, place the four profiles as shown, and
pay attention to the direction of the profiles.
2. Tighten the M5 screw in the shaft, and judge
Gap side outwarder
whether you have installed it correctly through
the enlarged view details.
Nota:
a. Place the screws, but do not tighten them.
b. Then tighten the screws diagonally.
c. Tools required, M5 Allen key+M5 screws.