Timer; Drainage; Continuous Drainage - ecofort ecoQ DryAir 12L Manuel D'instructions

Masquer les pouces Voir aussi pour ecoQ DryAir 12L:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Timer

OFF-Timer
Press the TIMER button to set the operating hour you need. There are 4 hour indicators above the
TIMER button: 1, 2, 4, 8 hours, however, the working hours can be accumulated, so it's not just 4
different hours you could set. For example, if you chose 1 and 2 hours at the same time, the unit will
work for 3 hours continuously. If you chose 1, 2 and 4 hours at the same time, it will work for 7 hours.
Thus, the max. working hours you could set is 15 hours, in case all these 4 indicators lights are on. As the
set time has been reached, the compressor will stop working automatically.
To turn off the unit manually, press the ON/OFF button again.
ON-Timer
By pressing TIMER button while the unit is off, you can pre-set the time for the machine to start
working. For example, if you press the timer to 2h, the unit will start to work automatically after 2 hours.

Drainage

When the water tank is full, the "Full Water" indicator will light on for alarm, the compressor will stop
for self-protection.
To move the water tank, pull it out squarely from the unit.
After emptying the water tank, place the water tank into space. Make sure it is properly positioned, in
order for the 'water full' sign to go out and your dehumidifier is operating.
Please note, in case, the water tank has not been positioned well, the water full indicator will turn red.

Continuous Drainage

When the dehumidifier is operated at very high humidity
levels, the water tank will require more frequent drainage. In
this situation, it may be more convenient to set the unit up
for continuous drainage with the following procedures:
1. Connect the spout for continuous drainage with a water
tube with an inner diameter of 12 mm. Please note, the
water tube is not supplied with the unit.
2. Ensure the water will always drain away freely and the
tube will remain in its place and in a downward position
from the unit.
53

Publicité

Table des Matières

Dépannage

loading

Table des Matières