Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Parts
Operation
Plug the unit into a correct mains socket. Press ON/OFF button to turn on the unit. The power
indicator will light on and the compressor will start to work.
Press humidity setting button to set the working mode you need: continuous working, humidity
40%, 50%, 60% or 70%. The relative indicator will light on.
After the selected target humidity in the room has been reached, the compressor switches off, the
operating display (1) goes out. The fan will switch to a lower speed and continue to run for 3 minutes to
further check the humidity in the room. If no increased humidity is detected by the device during this
time, the fan will also switch off.
To turn the unit off, press the ON / OFF button (2) again.
1. Power indicator
2. ON/OFF (power) button
3. "Full Water" indicator
4. Humidity setting button
5. Working mode indicator (continuous working,
humidity 40%, 50%, 60%, 70%)
6. Timer operation indicator
7. Timer button
52
Publicité
Table des Matières
Dépannage
