JVC KW-NT1 Manuel D'instructions page 41

Checking the information of the navigation system
1
GPS
5
Satellites
(Green): Receiving the GPS signals and used for the
calculation.
(Yellow): Receiving the GPS signals.
(Grey): Not receiving the GPS signals.
1 Current speed *
1
2 Direction of the car *
1
3 Latitude and longitude of your current position *
4 Altitude of your current position *
5 Date/Local time
• When the System cannot receive the GPS signals, the
value of each item above are shown as "- -."
System
6
7
8
9
t
6 Name of the unit
7 Version of the software
2
8 Version of the map database
9 Version of the voice guidance database
1
p Connection status of the ILLUMINATION CONTROL
2
3
4
q Connection status of the PARKING BRAKE lead
w Connection status of the REVERSE GEAR SIGNAL
e Status of the gyroscope
r Speed pulse rate
t Status of calibration *
1
1
1
*
2
p *
q
w
e
r
3
*
39
lead
<On>: The illumination signal is detected.
<On>: The parking brake is engaged.
lead
<On>: Reverse gear signal is detected.
• If the rear view screen is displayed when shifting
the gear to the reverse (R) position, the reverse
gear signal is detected (<On>).
2 3
*
<Processing>: The current position cannot be
determined without data from GPS satellites.
<Learning>: The current position can be
determined even when the System cannot receive
data from GPS satellites.
<Learned>: The current position can be
determined accurately even when the System
cannot receive data from GPS satellites.
These information may not be shown correctly when
the reception of GPS signals is poor.
The calibration does not function without the
connection of GPS aerial and the speed signal lead.
For the connection, ☞ Installation/Connection
Manual (separate volume).
Driving under various conditions completes the
calibration faster. If <Processing> remains on the
screen for long period, check the connection of the
GPS aerial and the speed signal lead.