Black & Decker KitchenTools FP2510SKT Mode D'emploi page 10

TROUBLESHOOTING
PROBLEM POSSIBLE C USE
Food is unevenly Workbowl is overfilled.
chopped. You may be running
the bowl continuously
instead of on PULSE
(P). Food may be cut in
random sizes.
Liquid leaks from the bot- Too much liquid in the
tom of the workbowl. workbowl.
Sliced foods are uneven The feed chute has not
and slanted. been well packed or
uneven pressure has
been applied to the food
pusher during processing.
Foods being sliced or This is normal.
shredded fill up on one
side of the bowl.
17
SOLUTION
Smaller amounts will
process more evenly.
Use the PULSE (P) button
in 5-second or less
increments. llow the
blades to stop completely
before pressing the
PULSE (P) button again.
Cut food in same size
pieces before placing in
processor.
Process smaller amounts.
When processing liquids,
do not add more than
3 cups to workbowl.
Do not remove the
blade before removing
workbowl from processor
when processing liquids.
Cut pieces in even
lengths, just a little
shorter than the length
of the feed chute. Pack
the chute carefully and
maintain even pressure
on the food pusher as the
food is being processed.
Stop processing
occasionally and either
even out the food in the
workbowl or move it to
another bowl. When food
accumulates close to the
disc, empty the workbowl
before continuing.
PROBLEM POSSIBLE C USE
Some pieces of food This is normal.
remain on top of the
slice/shred disc.
Soft cheese collects on The cheese was not cold
top of the slice/shred enough. The pressure
disc. exerted on the pusher
was too great.
SOLUTION
Slice or shred those
pieces by hand or save
for another use, like
soups that will be pureed.
Be sure soft cheeses are
well chilled or place
in freezer until knife
inserted into cheese
penetrates about ½-inch.
Remember food pusher
is to be used as a guide;
never exert hard pressure
on the food pusher.
18