Honeywell Prestige IAQ Guide D'installation page 13

Replacing system components
Equipment Interface Module
After installing a new Equipment Interface Module, you must re-link all
devices to the new EIM, as described below:
1. Install and wire new Equipment Interface Module.
2. Disconnect thermostat from the old Equipment Interface Module.
Installer Options
Wireless Device
MENU
HELP
Manager
Remove Device
Remove This
Thermostat
Press MENU.
MENU
MCR28801
Press
INSTALLER OPTIONS. Enter security code
when prompted.
Security code is the thermostat date
code (printed on back of wallplate). Or
press MENU > EQUIPMENT STATUS to find
code.
MCR28998
Press
WIRELESS DEVICE MANAGER.
MCR28802
Press REMOVE DEVICE.
Press REMOVE THIS THERMOSTAT.
MCR32406
13
2-wire Prestige® IAQ and RF EIM
to scroll down, then press
t
to scroll down, then press
t
69-2445EFS—03