Casio GRAPH95 Mode D'emploi page 437

k Trigger Setup
You can use the Trigger Setup screen to specify the event that causes sampling to start ( w
key operation, etc.) The event that causes sampling to start is called the "trigger source",
which is indicated as "Source" on the Trigger Setup screen.
The following table describes each of the six available trigger sources.
To start sampling when this happens:
When the w key is pressed
After the specified number of seconds are counted down
When input at CH1 reaches a specified value
When input at the SONIC channel reaches a specified value
(EA-200 only)
When the built-in microphone detects sound (EA-200 only)
When the [START/STOP] key is pressed (EA-200 only)
When [Button] is pressed (CLAB only)
Note
The trigger sources you can select depends on the sampling mode selected with the Sample
Setup (page 3-5).
For this sampling mode:
Realtime
Fast
Normal
Extended
Sound
Clock
Period
3-8
Using Advanced Setup
The following trigger source(s) can be selected:
[EXE] key, Count Down
[EXE] key, Count Down, CH1, Mic
[EXE] key, Count Down, CH1, SONIC, [START] key
[EXE] key
[EXE] key, Count Down, Mic
CH1
CH1
Select this trigger source:
[EXE] key
Count Down
CH1
SONIC
Mic
[START] key
[START] key