Table des Matières
Publicité
6. After all the settings are the way you want, press w.
• This returns to the Advanced Setup menu.
Note
• Whenever the current Channel Setup (page 3-3) and Trigger Setup (page 3-8) settings
become incompatible due to a change in Sample Setup settings, these settings revert
automatically to their initial defaults. Selecting "Realtime" as the sampling mode with
Sample Setup while the Mic channel is selected with Channel Setup and the Trigger
Setup has "Mic" selected for "Source", for example, will cancel the Channel Setup Mic
channel selection and change the Trigger Setup "Source" setting to "[EXE] key".
For information about the channels that can be selected for each sampling mode,
see step 2 of "To configure Sample Setup settings". For information about the trigger
sources that can be selected for each sampling mode, see "Trigger Setup" (page 3-8).
To configure the Distance setting
u
In place of step 3 of the procedure under "To configure Sample Setup settings", press 1 to
display a dialog box for specifying the distance the weight travels in meters.
• Specify a value in the range of 0.1 to 4 meters.
To configure the FFT Graph setting
u
In place of step 5 of the procedure under "To configure Sample Setup settings", press 1 to
display a dialog box for turning frequency characteristic graphing (FFT Graph) on and off.
To do this:
Turn on graphing of frequency characteristics after sampling
Turn off graphing of frequency characteristics after sampling
3-7
Using Advanced Setup
Press this key:
1(On)
2(Off)
Publicité
Table des Matières
