Environmental Information - Flymo Micro Lite Instructions D'origine

11. Never operate the product with damaged guards or
without guards in place.
12. Never fit metal cutting elements.
13. Keep hands and feet away from the cutting means at all
times and especially when switching on the motor.
14. Do not tilt the product when the motor is running, ex-
cept when starting and stopping. In this case, do not
tilt more than absolutely necessary and lift only the
part which is away from the operator. Always ensure
that the hand is in the operating position before re-
turning the appliance to the ground.
15. Never pick up or carry a product when it is operating
or still connected to the mains supply.
16. Remove the plug from the mains :
- before leaving the product unattended for any period;
- before clearing a blockage;
- before checking, cleaning or working on the appliance;
- if you hit an object. Do not use your product until you
are sure that the entire product is in a safe operating
CH
T o ensure you have a secure connection between the lawn-
mower and the extension cable we strongly recommend you
use the following method of attaching the cable:
1. Plug the short connection lead into the socket of the ex-
tension cable. (K1).
• Awareness of the environment must be considered
when disposing of 'end-of-life' product.
• If necessary, contact your local authority for disposal
information.
The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it shall be handed over to
the applicable collection point for the recycling of
electrical and electronic equipment.
• Your product is uniquely identified by a silver and black product rating label.
• We strongly recommend that your product is serviced at least every twelve months, more often in a
professional application.
If any part is found to be defective due to faulty
manufacture within the guarantee period, Husqvarna
UK Ltd., through its Authorised Service Repairers will
effect the repair or replacement to the customer free
of charge providing:
(a) The fault is reported directly to the Authorised
Repairer.
(b) Proof of purchase is provided.
(c) The fault is not caused by misuse, neglect or
faulty adjustment by the user.
(d) The failure has not occurred through fair wear and
tear.
(e) The machine has not been serviced or repaired,
taken apart or tampered with by any person not
authorised by Husqvarna UK Ltd.
(f) The machine has not been used for hire.
(g) The machine is owned by the original purchaser.
(h) The machine has not been used commercially.
* This guarantee is additional to, and in no way
diminishes the customers statutory rights.
Failures due to the following are not covered,
therefore it is important that you read the instructions
contained in this Operator's Manual and understand
how to operate and maintain your machine:
Safety

Environmental Information

Service Recomendations
Guarantee and Guarantee Policy
ENGLISH - 2
condition;
- if the product starts to vibrate abnormally. Check im-
mediately. Excessive vibration can cause injury.
Maintenance and storage
1. Caution: Do not touch rotating blade(s)
2. Keep all nuts, bolts and screws tight to be sure the
product is in safe working condition.
3. Replace worn or damaged parts for safety.
4. Only use the replacement spare parts and
accessories specified for your product.
5. Only use replacement parts and accessories
recommended by Husqvarna.
6. Be careful during adjustment of the product to pre-
vent entrapment of the fingers between moving cut-
ting parts and fixed parts of the machine.
7. Store in a cool dry place and out of reach of children.
Do not store outdoors.
8. Allow the product to cool for at least 30 minutes
before storing.
2. Form a loop in the end of the extension cable near to the
socket and secure this in the strain relief feature at the
top of the switchbox. (K2) This will cause the socket to
hang in a downward direction. (K3)
By ensuring this product is disposed of correctly, you
will help prevent potential negative consequences for
the environment and human health, which could
otherwise be caused by inappropriate waste handling
of this product.
For more detailed information about recycling of this
product, please contact your local council office, your
household waste disposal service or the shop where
you purchased the product.
Failures not covered by guarantee
* Failures as a result of not reporting an initial fault.
* Failures as a result of sudden impact.
* Failures as a result of not using the product in
accordance with the instructions and
recommendations contained in this Operator's
Manual.
* Machines used for hire are not covered by this
guarantee.
* The following items listed are considered as wearing
parts and their life is dependent on regular
maintenance and are, therefore not normally subject
to a valid warranty claim.
Plastic Cutters, Cutting Head, Electric Mains
cable.
* Caution!
Husqvarna UK Ltd. does not accept liability under
the warranty for defects caused in whole or part,
directly or indirectly by the fitting of replacement
parts or additional parts that are not either
manufactured or approved by Husqvarna UK Ltd.,
or by the machine having been modified in any
way.