Publicité
Les langues disponibles
Les langues disponibles
ATTACHING THE MULCHING PLUG (Fig. C7)
EN
Side Discharge
C7-1
Chute
C7-3 Movable Spring
ADJUSTMENT
BEFORE ADJUSTMENT (Fig. D1)
ADJUSTING THE CUTTING-DECK HEIGHT
(Fig. D2)
ADJUSTING THE ANTI-SCALP WHEELS
(Fig. D3 – D6)
D3-1 Anti-Scalp Wheel
D5-2 Lug Bolt
ADJUSTING THE SEAT (Fig. D7)
Seat Position
D7-1
Adjustment Lever
ADJUSTING THE STEERING WHEEL (Fig. D8)
D8-1 Locking Bolt
D8-3 Locating Block
OPERATION
BEFORE OPERATION (Fig. E1)
SETTING THE PARKING BRAKE (Fig. E2)
E2-1 Released Position E2-2 Braking Position
NOTICE:: Never depress the parking-brake pedal to
slow down the speed. Once the parking-brake pedal is
depressed enough but not to the full parking position,
the mower will stop moving on a flat surface, but if this
happens on a slope, the mower may slide down the
slope.
ATTACHING / DETACHING THE BATTERY PACK
(Fig. E3 – E6)
In order to start this mower, EGO batteries totaling 15 Ah
(2 X BA4200/BA4200T) or more are required. For best
performance, we recommended use of EGO batteries
24
ZERO TURN RIDE-ON MOWER — ZT4200E-S
C7-2 Mulching Plug
D5-1 Nut
D6-1 Deck Height Label
Seat Suspension
D7-2
Adjustment Knob
D8-2 Bar
D8-4 Slot
that total 30 Ah or more.
E3-1 Cover Release
Button
CHARGING THE MOWER
Use only with the recommended battery packs and
chargers.
◾
Charge the battery pack(s) separately (Fig. E7)
NOTICE: Refer to corresponding battery and charger
manuals for detail instructions.
◾
Charge the battery pack(s) via charging port
(Fig. E8-E10)
E10-1 Dust Cap
TESTING THE SAFETY INTERLOCK SYSTEM
a. To test the deck-blade system (Fig. E11 – E12)
b. To test the driving system (Fig. E13 – E14)
If the deck-blade system and/or the driving system fails
to stop when the operator is off of the seat and if the
cause cannot be determined after confirming the plug
and socket connection of the seat is well connected,
contact your EGO customer service center immediately.
CHECKLIST BEFORE OPERATION
◾
Ensure that the work area is clear of children,
bystanders, and pets.
◾
Clear the work area of objects that may be thrown
by the mower blades.
◾
Clean debris from the mower.
◾
Check for loose fasteners.
◾
Check to make sure that all guards are in place
and working properly.
◾
Visually check the tires whether they are inflated.
◾
Check the brake operation.
◾
Adjust the deck height to the desired cutting
position best suited for the lawn, and adjust anti-
scalp wheels accordingly.
◾
Adjust the seat position and make sure both
pedals can be reached.
◾
Adjust the steering wheel to desired position if
necessary.
◾
Verify the battery charge level.
◾
Test the safety interlock system.
E5-1 Battery Release
Button
E10-2 Charging Port
Publicité
