Battery Installation; Battery Replacement - Yamaha RX-V495 Mode D'emploi

NOTES ABOUT THE REMOTE CONTROL TRANSMITTER

Battery installation

1
3

Battery replacement

If the remote control transmitter operates only when it is close
to the unit, the batteries are weak. Replace all batteries with
new ones.
Be sure to replace batteries within about two minutes. If it
takes longer than two minutes, the codes preset for the
remote control transmitter will return to the factory-set.
Notes
• Use only AAA, R03, UM-4 batteries for replacement.
• Be sure the battery polarity is correct. (See the illustration
inside the battery compartment.)
• Remove the batteries if the remote control transmitter will not
be used for an extended period of time.
• If the batteries have leaked, dispose of them immediately.
Avoid touching the leaked material or letting it come into
contact with clothing, etc. Clean the battery compartment
thoroughly before installing new batteries.
52
2
Remote control transmitter operation range
Remote control
sensor
Notes
• There should be no large obstacles between the remote
control transmitter and the unit.
• If the remote control sensor is directly illuminated by strong
lighting (especially an inverter type of fluorescent lamp, etc.),
it might cause the remote control transmitter not to work
correctly. In this case, reposition the unit to avoid direct
lighting.
Within approximately
6 m (20 feet)