Variable Speed Control - TMC Reef Pump Manuel D'instructions

OPERATION OF THE DC CONTROLLER

Variable Speed Control

With 20 different speed settings to allow precise adjustment of water flow
and optimum performance.
When the Reef Pump Connect is switched on, the LCD screen on the
controller will display 1-01 (Constant Flow Mode – speed
setting 1). To increase the speed of the pump press "+" until
you reach the required level (maximum level will be displayed
on the LCD screen as 1-20 (Constant Flow Mode – speed
setting 20). To decrease speed press "-".
Feed Mode
Press "FEED" to pause pump operation for 10, 20 or 30 minutes.
When you enter FEED Mode the LCD screen on the controller will display
F-10, F-20 or F-30 (Feed Mode 10, 20 or 30 minutes) and the pump will stop
pumping. The controller will then start a 10 minute countdown which will be
displayed on the LCD screen of the controller, starting at F-10 and counting
down in minutes to F-09, F-08 and so on until it displays F-00, at which point
the feed time have elapsed and the pump will resume operation and
start pumping.
If you wish to restart the pump before the end of the 10, 20 or 30 minute pause,
press FEED again and the pump will restart.
9