TMC Reef Pump Manuel D'instructions page 11

MAINTENANCE
Caution: Always isolate the PSU from the mains electricity before
installing or carrying out any maintenance to the pump.
1. Regular maintenance will prolong your pump's life. To clean the pump,
unplug from the mains electricity supply, disassemble and rinse all parts
with fresh water, using a soft brush to remove any debris/detritus inside,
then re-assemble.
Please Note: The pump impeller shaft cannot be removed from the impeller.
2. The impeller should be regularly checked for signs of degradation and
replaced as necessary. Please Note: The impeller is not covered under
the guarantee.
3. Always check the condition of the pump O rings and replace if damaged
in any way.
4. Impellers, O rings and a range of other spare parts are available from your
local TMC stockist.
TROUBLE-SHOOTING
If the pump fails to operate:
1. Check that the pump is connected to the electricity supply.
2. Check the pump inlets and outlets for any debris or blockages. Please
flush out any debris with fresh water.
3. Remove the pump cover to access the impeller area. Turn the impeller
to ensure it is not broken or jammed.
GUARANTEE
This product, except for the impeller, is guaranteed against defects
of materials and workmanship for a period of 1 year from the date
of purchase.
This guarantee is only valid if the receipt or other proof of purchase is also
supplied when the unit is returned for repair.
The guarantee covers the replacement of any defective parts. In case
of improper use, tampering or negligence by the buyer/user, the guarantee
is deemed to be void.
Only use the correctly-rated controller supplied with the pump, for example
the Reef Pump Connect 2500 controller with the Reef Pump Connect 2500.
A label on the back of the controller denotes which pump it is designed for.
Using the wrong controller with the wrong pump will invalidate this
guarantee. Postage and packing costs for any returns are the responsibility
of the buyer/user.
11