TMC Reef Pump Manuel D'instructions page 3

INSTRUCTIONS FOR INSTALLATION AND USE
Important Safety Information-Please Read Carefully
Caution: Do not use any power supply other than the one
supplied with your genuine Reef Pump Connect.
The use of a different power supply will invalidate the guarantee.
• Always isolate the PSU from the mains electricity before instaling
or carrying out any maintenance to the pump. Caution: The Reef Pump
Connect controller is not waterproof and therefore must not be mounted above
the aquarium or sump, or in any position where it may accidentally fall into
water or be splashed by water, or in a humid environment.
• Only use the correctly-rated controller supplied with the pump, e.g the Reef
Pump Connect 2500 Controller with the Reef Pump Connect 2500. A label on
the back of the controller denotes which pump it is designed for. Using the
wrong controller with the wrong pump will invalidate the guarantee.
• Power to the pump must be supplied through a Residual Current Device (RCD)
with a rated residual operating current not exceeding 30mA.
• Never operate the pump without water inside the impeller chamber or with
liquids at a temperature higher 95oF/35oC.
• To ensure the pump continues to maintain a steady water flow, it must be
cleaned regularly to ensure it does not become clogged with debris or detritus.
• Pump rating: 100-240V, 50/60Hz unless marked otherwise.
• Do not operate any appliance if it has a damaged cord or plug, if it is
malfunctioning, or if it has been dropped or damaged in any way.
• This unit is designed to be used indoors and is not suitable for any
outdoor applications.
• Ensure the Reef Pump Connect is securely installed before operating.
• Always leave a drip-loop in the pump cable to prevent water running down the
cable and reaching the controller and power source (see diagram below).
• Dispose of this unit responsibly. Check with your local authority for
disposal information.
3