TMC Reef Pump Manuel D'instructions page 8

INSTALLATION
1. Install the feet in the holes on the underside of the pump body (see photo 1)
and attach a hosetail and hosetail O ring as required (see photo 2).
2. Install and secure the Reef Pump Connect controller in a suitable location
where it can be easily accessed and adjusted e.g. on the side or back of your
aquarium cabinet, but ensuring it is NOT mounted above the aquarium or
sump, or in any position where it may accidentally fall into water or be
splashed by water.
3. Install the pump in your desired location e.g. sump, ensuring that it is fully
submerged and secured.
4. Connect the pump and the power supply unit (PSU) to the controller
(see photo 3).
5. Connect the PSU to the mains electricity supply and switch on.
1.
3.
.
8
2.