Initial Start Up; User Buttons - Graco 127650 Mode D'emploi

H INITIAL START UP
EN
FOREWORD
WARNING
NOTICE
NOTICE
NOTICE
NOTICE
I FEATURES
FOREWORD
1 Partial register (5 figures with moving comma
FROM 0.1 to 99999) indicating the volume dis-
pensed since the reset button was last pressed
2 Indication of battery charge
3 Indication of calibration mode
4 Totals register (6 figures with moving comma FROM
0.1 to 999999), that can indicate two types of Total:
4.1. General Total that cannot be reset (TOTAL)
4.2. Resettable total (Reset TOTAL)
5 Indication of total multiplication factor (x10 / x100 )
6 Indication of type of total, (TOTAL / Reset TOTAL);
7 Indication of unit of measurement of Totals:
L=Litres Gal=Gallons
Indication of Flow Rate mode
8
9 Indication of unit of measurement of Partial:
Qts=Quarts
L=Litres
I1 USER BUTTONS
FOREWORD The METER features two buttons (RESET and CAL) which individually perform two
main functions and, together, other secondary functions.
MAIN FUNCTIONS - for the RESET key, resetting the partial register and Reset Total
PERFORMED - for the CAL key, entering instrument calibration mode
SECONDARY Used together, the two keys permit entering configuration mode where the de-
FUNCTIONS sired unit of measurement can be set.
10
Only start dispensing after making sure that assembly and
installation have been correctly performed.
TOXIC FLUID OR FUMES HAZARD
The faulty operation of this device could cause the spill
of liquids that are hazardous for people and the envi-
ronment.
It is a good practice to only operate the nozzle lever
after making sure the spout has been properly in-
serted in the mouth of the tank to be filled.
When using for the first time and every time the
nozzle is used, following the connection of the sup-
ply hose, gently operate the lever to enable the air
to escape from the circuit, until normal operation is
achieved.
Check the correct operation of the automatic stop
device once the tank is full.
Keep fresh water in nozzle path to prevent DEF
crystals from forming on nozzle end. The nozzle au-
tomatic shut off may fail if crystallization plugs the
nozzle orifice. The nozzle tip must be submerged in
water when the nozzle is holstered.
The "LCD" of the METER features two numerical registers and various
indications displayed to the user only when the applicable function so
requires.
1
2
3
Pts=Pints
Gal=Gallons
9
8
7
6
4 5
M0303