Important Information; About This Document; Mounting Instructions - DURAVIT Happy D.2 7003120 Notice De Montage

Important information

About this document

All documents related to this product and further
information are available online:
> Access online documents at qr.duravit.com or
www.duravit.com.
Safety
Purpose of the document
The instructions are part of the Duravit product. Failure
to follow the instructions may result in personal injury,
product damage and/or property damage.
> Read and follow the instructions.
> Keep this document and pass it on to subsequent
users.
We reserve the right to make technical improvements
and visual changes to the products illustrated.
Target readership and qualifications
All work associated with the installation may only be
undertaken by plumbers.
− Plumbers are persons with the appropriate technical
training, knowledge and experience so that they can
recognise and avoid dangers and risks that may arise
during the installation in the sanitary area.
− Plumbers are qualified to select and use suitable
protective equipment.
− Plumbers are familiar with and observe the installation
regulations of local utility companies and country-
specific standards.
Avoiding damage
Product and/or property damage
A breach of local and country-specific regulations and
standards can cause damage to the product and/or
property damage.
> Observe the local installation regulations and any
country-specific standards at all times.
Requirements at the installation location
The pre-installation is carried out properly.
> Access the pre-installation data sheet at qr.duravit.
com or www.duravit.com.

Mounting instructions

13
Mounting the cable-driven waste and overflow
The connecting hose #790159/#790166 is
recommended for mounting a bath spout with a
waste and overflow set or base inlet.
28 Providing for an inspection hatch
> Provide for an inspection hatch in the area of the
cable-driven waste.
> Dimensions of the inspection hatch: min. 20 x 20
cm / 50–50".
35 Close the inspection hatch
> Seal the inspection hatch against spray water.
> The inspection hatch may only be opened with a
tool.
5
MI_70000675_59209_22.07.10