DeLonghi EL Serie Mode D'emploi page 10

Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries. Do not dispose of batteries in fire.
Batteries may explode or leak. If the remote control is not be
used for a certain length of time, remove the batteries.
USING THE REMOTE CONTROL
• Point the remote control at the receiver (A5) on the air
conditioner. The remote control must be no more than 23
ft (7 metres) away from the appliance (without obstacles
between the remote control and the receiver).
• The remote control must be handled with care. Do not drop
it or expose it to direct sunlight or sources of heat.
max 23 ft
max 7 m
Note: The remote control can be safely stored in the
appropriate compartment A6 (see figure page 3).
DESCRIPTION OF THE REMOTE CONTROL
D1) ON/STAND-BY button
D2) Arctic Whisper button
D3.1) Air flow increase/decrease button
D3.2) Temperature increase/decrease button
D4) Swing button (flap swing)
D5) Timer button
D6) MODE button
D
D6
D3.2
D3.2
D5
D1
D2
D3.1
D3.1
D4
10
TURNING THE APPLIANCE ON
• Plug into the outlet.
• Press the button (D1) (when turned on, the air
conditioner starts operating in the same mode as when it
was turned off) .
• To switch the appliance off, press button (D1)
Note: Never switch the appliance off by removing the plug.
Always switch it off by pushing the
minutes before removing the plug. Only in this way the appli-
ance will perform the standard checkings.
SELECTING THE OPERATING MODES
Most of the commands available on the remote control corre-
spond to those on the appliance control panel (C).
SELECTING THE TEMPERATURES
In conditioning and heating modes press button D3.2 to select
the desired temperature.
SELECTING THE AIR FLOW
In conditioning and fan modes, press button D3.1 to select the
desired air flow.
The air flow available are:
Minimum air flow: when maximum silent
operation is desired.
Medium air flow: when the noise level needs to
be low but with a good comfort level.
Maximum air flow: for maximum performance.
The appliance automatically chooses the air flow based
on the temperature selected and the environmental
conditions (This is available only in the air conditioning
mode).
ARCTIC WHISPER (available in conditioning mode
only)
By activating this function, the operating noise is further re-
duced. To activate it, press
control.The display shows the relative symbol (C12).
/
OFF
.
button and waiting few
(D2) button on the remote