Barrette rdi Serie Instructions D'installation page 5

2.
NOTE: For installation on line and corner posts,
rail covers are not included with over-the-top
brackets and are not needed. Top rails should be
cut (Fig. 1) and aligned together on the bracket
above the post (mitre cut if a corner) (Fig. 2).
For end posts, an additional bracket cover is
included and will be used.
Install deck board on top of railing systems.
Deck boards will run over the top of line posts
and should be mitre cut in the corners. For end
posts, deck board can terminate even with the
end of the rail/bracket cover or extend slightly
past.
3.
Once deck boards are centered and in place,
secure deck boards to railing system adapter
using provided #10 x ¾" screws in the
predetermined locations punched in the rail on
both sides along the length of the rail (Fig. 3).
When installing, locate and fasten the screws into
the center of the slot to allow for expansion and
contraction. Secure screws on both sides of the
rail as close to the post as possible at both ends.
Use remaining screws and install evenly along the
length of the rail.
Fig. 2
Fig. 3
5