Rt100 Installation - Dometic RainTec RT100 Instructions De Montage

RainTec RT100
6

RT100 installation

6.1 Required installation material
For the installation of the rain gutter, you will need:
 Drill bit with 3 mm diameter
 Screwdriver or bit with drive TX15
 Suitable flexible sealant, e.g. Sikaflex
6.2 Notes on the installation position
When choosing the installation location, observe the following:
NOTICE!
A
 The cables and cabinets in the interior of the vehicle may not be
damaged by drilling the holes.
 For optimal adhesion mount the rain gutter at ambient temperatures of
18 – 22 °C.
6.3 Installing the RT100
➤ Before installation, test to see if the lighting works.
See fig. 2 to fig. 8
Supplementary to fig. 2
➤ Clean the area on the wall of the vehicle above the sliding door.
The adhesive surface must be clean, free of grease and oil, and dry.
Supplementary to fig. 4
I
NOTE
The rain gutter can no longer be moved if the adhesive surface is
on the vehicle wall. Check beforehand for correct alignment.
➤ Guide the connection cable down and out.
➤ Align the rain gutter in a centred fashion using the two inclined surfaces
at the sides and then press them into the wall of the vehicle.
EN
RT100 installation
®
-252
13