General Usage; International Warranty - Bell & Ross BR S QUARTZ Notice Technique

BR S QUARTZ
BR-CAL.102
Movement : quartz. Calibre BR-CAL.102. Functions
hacking function. : 39 mm diameter.
Case

GENERAL USAGE

Starting the watch : the watch starts running once the battery has been fitted.
Setting the time . Pull the crown out to position 2. The seconds hand will stop, enabling you to set the time
to the nearest second. Set the time by rotating the crown in the required direction.
. (crown in position 1): pull the crown out to position 1 and set the date by rotating the
Setting the date
crown anticlockwise. Slow setting (crown in position 2): to ensure the date changes at midnight rather than
noon, it is recommended you set the date by adjusting the hands of the watch. Pull the crown out to position 2
and turn the hands until the date changes. Then set the precise time.
IMPORTANT
. As with all watches with a date function, quickset date setting (crown in position
*Quickset date setting
1) MUST NOT UNDER ANY CIRCUMSTANCES be carried out between the times of 9 P .M. (21:00) and 3 A.M.
(03:00).
Water resistance . Once the watch is set, to ensure perfect water resistance, push the crown back to posi-
tion 0. Never operate the crown underwater.
Note : The 4 slotted screws (D) mount the bezel to the case and ensure the water resistance of the watch. To
benefit from the Bell & Ross warranty, these screws must never be unscrewed.
MAINTENANCE
After being immersed in seawater, it is recommended to carefully rinse off the watch and strap with fresh
water. It is also recommended to have the water resistance of your watch checked every two years.
: hours, minutes, seconds* and date*. Time-setting with

INTERNATIONAL WARRANTY

To benefit from your 2-year international warranty, your card must be activated at the time of purchase by
your approved Bell & Ross point of sale, and presented every time an intervention is performed. You can now
access the digital version of this card and all the information relating to your watch by scanning the QR code
or visiting: www.bellross.com/warranty
To ensure a service that meets the brand's exacting standards, any servicing of your watch must be carried
out by the Bell & Ross service centre or a watchmaker approved by Bell & Ross.
A.
Minute hand
B. Hour hand
C. Seconds hand*
D. Case attachment screws
(NEVER UNSCREW)
E.
Date*
F. Crown
1.
Set the date (rotate anticlockwise)
2.
Set the time (rotate in either direction)
*Seconds hands and date on certain models only
A
0
B
C
E
D
(x4)
2
1
F