Manually Connecting The Subwoofer Or Surround Speakers If Automatic Connection Fails - Samsung Harman/Kardon HW-Q90R Mode D'emploi

Masquer les pouces Voir aussi pour Harman/Kardon HW-Q90R:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 45

Manually connecting the Subwoofer or Surround Speakers if automatic connection fails

Before performing the manual connection procedure below:
• Check whether the power cables for the Soundbar and subwoofer or Surround Speakers are
connected properly.
• Make sure that the Soundbar is turned on.
1. Press and hold ID SET on the rear of the subwoofer and surround speakers for at least 5 seconds.
• The red indicator on the rear of each speaker turns off and the blue indicator blinks.
x 2
2. Press and hold the Up button on the remote control for at least 5 seconds.
• The ID SET message appears on the display of the Soundbar for a moment, and then it
disappears.
• The Soundbar will automatically power on when ID SET is complete.
5 Sec
Rear of Subwoofer
POWER
Rear of the Left and Right Surround Speakers
"Samsung Harman Kardon" logo is on the top
5 Sec
5 Sec
ENG - 7
Blue LED Blinking Fast
ID SET

Publicité

Table des Matières
loading

Table des Matières