Télécharger Imprimer la page

Chariot BABYSITZ Mode D'emploi page 9

Publicité

Les langues disponibles

Les langues disponibles

Note: Depending on the carrier that you have purchased, it may be easier to install the straps
if the carrier is partially folded.
Figure 13a
CORSAIRE or CORSAIRE XL ONLY - If you have a Corsaire or Corsaire XL carrier and
are mounting the Infant Sling in the outside position, wrap the outer strap around the
aluminum bar behind the seat and thread the strap into the ladder lock as shown below.
Thread the inner strap on the carrier's upper seat back through the inner ladder lock on the
Infant Sling. Tighten the straps fully. See Figures 14a, 14b, 14c.
Figure 14a
If you are mounting the Infant Sling in the middle position of a Corsaire or Corsaire XL, use
both of the straps in the middle of the carrier's upper seat back.
C. Lower Attachment
Fasten the lower straps around the lower anchor bar and then into the ladder locks. Pull the
Infant Sling to verify that the ladder locks are maintaining the tension in the straps. See
Figures 15a, 15b.
Figure 15a
Figure 13b
Figure 14b
Page 9 of 13
Figure 13c
Figure 14c
Figure 15b

Publicité

loading