Chariot BABYSITZ Mode D'emploi page 10

D. Lap Belt Buckle
Your Chariot Carrier comes with the seat belts arranged so that the Infant Sling can be
installed in either outer seat position. The Infant Sling can also be installed in the center
location if you only have one passenger.
There are two lap belt compatible clips on the rear of the Infant Sling. See Figure 16a. These
are used to anchor the sling to the lap belt restraints to limit the side to side motion of the
Infant Sling during use. For the outer seat position, loosen the lap belt adjustments and clip
the Infant Sling to the lap belt restraint. See Figures 16b, 16c. For the middle seat position,
loosen the outermost lap belt restraint from each seating position and clip them to the back of
the Infant Sling. See Figures 16d, 16e.
Figure 16a
Figure 16d
E. Shoulder Harness
Depending upon the year and model of your carrier, the shoulder harness will vary in the way
it is attached to your carrier. Please refer to the owner's manual for instructions on how to
remove and replace the shoulder harness. If you do not have the owner's manual for your
carrier, you can download a copy from our website
"Customer Service" and "Owner's Manuals".
To place the Infant Sling in one of the outer seats, remove the shoulder harness from the
carrier and thread the straps through the appropriate slots in the infant sling. For a smaller
child use the lower slots, for a taller child use the higher slots. Reattach the shoulder harness
to the carrier. See Figure 17a, 17b.
Figure 16b
Page 10 of 13
Figure 16c
Figure 16e
www.chariotcarriers.com under