Chariot BABYSITZ Mode D'emploi page 3

1. Single Child Carrier
A. Installing the Front Mounting Parts to your Carrier (one time installation)
Any reference to orientation (left or right) is from the passenger's point of view while in the
carrier.
The arrow indicates the drilled hole location in the carrier's left front frame. See Figure 2.
Older carriers have a bare through hole, newer carriers have a nut that is permanently
installed with a bolt attached on the inside.
Older carrier – Place the D-rings on the shorter (1 3/8") bolts from the hardware bag. Insert
the bolt and D-ring into the hole in the upper frame from the top or front orientation between
the frame and the fabric. See Figure 3a. Depending on the carrier that you have purchased,
it may be easier to insert the bolts if the carrier is partially folded. Place a nut on each bolt
and tighten the nut and bolt with a Philips screwdriver and a 7/16" or 11mm wrench. Tighten
the nut and bolt until the end of the bolt is flush with the nut.
Newer carrier - Using a Philips screwdriver, remove the pre-installed bolt from the nut
secured in the carrier's upper frame. Place the D-ring on the bolt and re-install the bolt into
the carrier's upper frame to engage the pre-installed nut. Tighten the bolt until secure. See
Figure 3b.
Figure 2
B. Top Attachment
There is a top and bottom orientation to the Infant Sling. Position the Infant Sling in the
carrier so that the grey padded cushion on the end of the sling is at the foot well of the
carrier. Fasten the two Infant Sling straps around the upper seat frame of the carrier.
Feeding the strap around the bar from the bottom, pull the strap up and around the bar and
then into the ladder lock and tighten. See Figures 4a, 4b, 4c.
Note: Depending on the carrier that you have purchased, it may be easier to install the straps
if the carrier is partially folded.
Figure 3a
Page 3 of 13
Figure 3b