Shoulder Harness - Chariot BABYSITZ Mode D'emploi

Figure 4a
C. Lower Attachment
Thread the Infant Sling straps through the D-rings and then into the ladder locks. Thread the
Infant Sling straps up though the ladder lock, pull it over and towards yourself, then thread
the straps back down through the ladder lock. Pull the Infant Sling to verify that the ladder
locks are maintaining the tension in the straps. See Figures 5a, 5b, 5c.
Figure 5a
D. Lap Belt Buckle
There are two lap belt compatible clips on the rear of the Infant Sling. See Figure 6a. These
are used to anchor the sling to the lap belt restraints to limit the side to side motion of the
Infant Sling during use. Loosen the lap belt adjustments inside the carrier and clip the Infant
Sling to the lap belt restraint. See Figures 6b, 6c.
Figure 6a
E. Shoulder Harness
Depending upon the year and model of your carrier, the shoulder harness will vary in the way
it is attached to your carrier. Please refer to the owner's manual for instructions on how to
Figure 4b
Figure 5b
Figure 6b
Page 4 of 13
Figure 4c
Figure 5c
Figure 6c