Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GAS AND ELECTRIC SUPPLY ZONES:
FIG. 3A Gas & Electrical Supply Zones for All Gas Ranges
Typical placement shown.
Other placement of
Electrical Supply and
Receptacle within the
Electrical and Gas Supply
Zone is acceptable.
NOTE:
If not already
present, install
gas shut-off valve
in an easily
accessible
location. Make
Protrusion from Wall
sure all users
know where and
how to shut off
the gas supply to
the range.
Model
30"
NOTE: The
36"
installer should
inform the
48"
consumer of the
location of the
NOTE: Any opening in the wall behind the appliance
gas shut-off valve.
and any opening in the floor under the appliance
must be sealed.
IMPORTANT:
The cord supplied with gas ranges having electric griddle requires
a NEMA 5-20 receptacle, shown here. Local codes may require
a different wiring method.
Step 2: Cabinet Preparation
3/4" Flex Line to
Appliance
Gas
1/2"
Supply
NPT
Zone
2" Maximum
for Gas Supply
Floor
A
B
C
8"
12"
10"
10-1/2"
15"
10-1/2"
16-1/2"
16"
15-1/2"
The All Gas ranges may be con-
nected to the power supply with a
range supply cord (supplied with
range) or by hard-wiring to the power
supply. It is the responsibility of the
installer to provide the proper wiring
components (cord or conduit and
120 VAC Receptacle
(Shown) or Junction
wires) and complete the gas con-
Box
nection as dictated by local codes
Centerline of
Electrical
and ordinances, and/or the National
Supply Zone
Electric Code. The units must be
properly grounded. Refer to Step 6
for details.
D
E
The range must be connected
only to the type of gas for which
it is certified. If the range is to be
connected to propane gas, ensure
D
E
that the propane gas supply tank is
6-1/2" 5-1/4"
equipped with its own high pressure
6-1/2" 5-1/4"
regulator in addition to the pressure
regulator supplied with the range.
6-1/2" 5-1/4"
(See Step 5.)
6
PLUG
NEMA 5-20
RECEPTACLE
Publicité
Chapitres
Table des Matières
