Valor H6 Serie Directives D'installation page 2

Installation
1. On completion of fi replace installation, screw the
linerbox bracket to top face of fi rebox with 4 screws.
2. Assemble the heatshield to the underside of the top
part of the steel front panel with 5 screws.
3. Carefully position and secure steel front panel with
4 low profi le screws to 4 fi rebox mounting brackets.
Before tightening, hold panel up against wall fi nish
then tighten.
2
4. Slide the removable panel in the clip on the
horizontal supports on each side and push it in until
fl ush with the front trim.
5. Identify left hand door from right using diagram
below.
LH Door
finger grip inboard, finger grip inboard,
with locator on left with locator on right
RH door has a
slot in upper
locator tab
RH Door