Service Notes - Laserworld Club Série Mode D'emploi

5. Service notes

Moisture and heat can reduce lifetime of the laser system dramatically and expires
any warranty claim.
• Quick on/off switching of this de-
vice will reduce durability of the
laser diode dramatically.
• Avoid sharp knocks and shocks to
this device and ensure sufficient
protection during transportation.
Look after your Laserworld pro-
duct.
• To increase durability of your laser,
protect device against overhea-
ting:
• Always ensure sufficient venti-
lation.
• Do not face spotlights (especially
moving heads) to the device.
• Check temperature after approx.
30 minutes with each new
installation. If necessary install the
projector at a place with different
temperature.
• Keep the device dry. Protect it
from moisture, rain and damp.
• Switch off device when it is not
needed. Diodes are switched on
and can wear out even if there is
no visible laser output.
EN page 5 / 12
• Please ensure the fans and hea-
tsinks are clear from dust and
debris otherwise the risk of over-
heating may occur. If the unit and
airways appear to be blocked then
please contact a qualified service
engineer to maintain and service
the product.
• The devices of Ecoline, Evolution,
Club and Proline Series are not
meant for professional applica-
tions. After approx. one hour of
operation, the device should cool
down for about 15 minutes.
• Removal of the warranty label
as well as damages to the device
caused by improper handling,
neglect of the safety instruc-
tions and service notes will void
the warranty.
Manual: Club Series MKII