Avantgarde AFU137DW Manuel D'utilisation page 21

Congélateur vertical
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5.TROUBLESHOOTING
You can solve many common freezer problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling the Service Center.
PROBLEM
Freezer does not operate.
Compressor turns on and off frequently.
Temperature inside the freezer is too warm.
Temperature inside the freezer is too cold.
Popping or cracking sound when compressor
comes on.
Bubbling or gurgling sound, like water boiling.
Code E2
Code E5
Code E6
Code E7
Code E9
TO CONTACT OUR SERVICE DEPT.
A.G.I SERVICE
450.963.1303/1.888.651.2534
service@aginternational.ca
POSSIBLE CAUSE
Not plugged in.
The circuit breaker tripped or a blown fuse.
The freezer temperature control is set at "0/OFF".
The room temperature is hotter than normal.
A large amount of food has been added to the
freezer.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The freezer does not have the correct clearances.
The freezer has recently been disconnected for a
period of time. Four hours are required for the
freezer to cool down completely.
Temperature control is set too warm. Turn the control
to a cooler setting and allow several hours for the
temperature to stabilize.
Door is kept open too long or is opened too
frequently. Warm air enters the freezer every time
the door is opened. Open the door less often.
The door is not closed completely.
The door gasket does not seal properly.
A large amount of warm or hot food might have been
stored recently. Wait until the freezer has had a
chance to reach its selected temperature.
The freezer has recently been disconnected for a
period of time. Four hours are required for the
freezer to cool down completely.
Temperature control is set too cold. Turn the control
to a warmer setting and allow several hours for the
temperature to stabilize.
Metal parts undergo expansion and contraction, as in
hot water pipes. This is normal. Sound will level off
or disappear as freezer continues to run.
Refrigerant (used to cool freezer) is circulating
throughout the system. This is normal.
Freezer temperature sensor failure
Freezer defrosting sensor failure.
Communication failure
Ambient temperature sensor failure
Freezer high temperature.
21

Publicité

Table des Matières
loading

Table des Matières