Installation Instructions - Avantgarde AFU137DW Manuel D'utilisation

2. INSTALLATION INSTRUCTIONS

To ensure that you get the best results from your new freezer, please take time to follow
these initials steps.
A. ELECTRICAL CONNECTION AND CLEARANCE
It is recommended to use a separate electrical circuit serving only this appliance.

This appliance is designed to be FREE STANDING ONLY, and should not be recessed or
built-in.

Place your freezer on a floor that is strong enough to support the freezer when it is fully
loaded.

Allocate 10 cm (100mm, 8 inches) of space on each side of the unit, 10 cm (100mm, 4
inches) in the back , and 30 cm (300mm, 12 inches) on top of clearance to allow the proper
air circulation.

Locate the freezer away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption. Extreme cold ambient
temperatures may also cause the freezer not to perform properly.

Install the unit where the room temperature is between 0°C (32°F) and 43°C (110°F)

Avoid locating the freezer in moist areas.

Plug the freezer into an exclusive, properly installed-grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord.
Any questions concerning power and/or grounding should be directed toward a
certified electrician or an authorized Service Center.

Do not use this appliance with an electric cord or adaptor.
15