Handle Installation - Avantgarde AFU137DW Manuel D'utilisation

B. UNPACKING AND CLEANING YOUR APPLIANCE
· Remove tape and any labels from your fridge before using (except the rating label).
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to
remove tape or glue. These products can damage the surface of your refrigerator.

Clean your freezer before usage: use a sponge, cloth or paper towel and mild detergent in
warm water to clean outside and inside of freezer, door liner and gasket. Rinse and dry
thoroughly.

Do not switch on the fridge immediately after vertical placement. Turn it only after a period 6
hours to ensure proper operation.

Allow the freezer to cool 2 to 3 hours before filling with frozen food.
C. HANDLE INSTALLATION
Note: Figures in the user manual are only for reference.
The refrigerator must be disconnected from the source of electrical supply before starting the
installation.

First, take out the two crisscross-screws and install them into the door holes, then turn the
screws until they are set in place (reach the substructure)
 Position the handle over the screws
 Put the other set screws in the hole on the side of the handle and turn until tight.
D. LEVELLING
If the fridge is not leveled the doors may not close or seal properly, causing cooling, frost, or
moisture problems. It is very important of the fridge to be level in order to function properly.To
level your fridge you may either turn the level leg clockwise to rise the side to the fridge or counter
– clockwise to lower the side.
)
(SOME MODELS
16