Tivoli Audio PAL+ Manuel Du Propriétaire page 12

EQ settings. Selecting a preset EQ will over-ride any adjustment made to the Bass
and Treble settings, but Loudness will be unaffected. The "Flat" EQ restores the audio
settings to the factory defaults, meaning Bass and Treble will be re-set to zero. The
"Flat" EQ also restores Loudness Off. However, if the Bass and Treble values have been
adjusted, those settings will still be shown in "User EQ". Simply selecting "User EQ"
will reactivate the Bass and Treble settings. In the EQ menu page, the numbers to the
right hand side indicate the bass and treble settings.
3. BALANCE (FOUND UNDER TIVOLI EQ): Press the pq buttons to alter the balance.
This control only affects the Headphone Output.
4. TIME (FOUND UNDER SETTINGS):
Set 12/24 hour: Press the Select button and use the pq and Select buttons to choose
a 12 or 24 hour clock format.
Set Time/Date: Press the Select button and use the pq and Select buttons to adjust the
hour and then minutes, immediately followed by the date. You must set the Auto update
to "No update" in order to set the time manually. For more, refer to "Auto update" below.
Auto Update: Press the Select button and use the pq and Select buttons to choose
between "Update from any", "Update from DAB" (also DMB), or "Update from FM" (RDS).
For any of the auto updates to work, you must have consistent reception of DAB or
FM RDS with a time/date signal provided. It could take up to a minute or more for the
clock to update. Tivoli Audio is not responsible for inaccurate time/date information
provided by the auto update signal.
To set the clock manually, select "No Update", and then select "Set Time/Date" under
the "Time" menu using the pq or t u buttons and the Select button to set the hour.
Repeat to set the minutes and press Select to save. Within this same "Time" menu are
additional options to set the date format and 12/24 hour clock mode.
NOTE: During a power outage, the alarm time(s) and clock will be maintained by an inte-
grated back-up memory. When "Auto update" is set to "Update from any", the radio may
find the clock signal from the last listened station, even when the PAL + is in standby.
Set Date Format: Press the Select button and use the pq and Select buttons to choose
the date format you prefer.
5. BACKLIGHT (FOUND UNDER SETTINGS):
Timeout: The backlight level is configured at the factory to be constant. However,
you can customize the backlight to automatically change to a "Dim level" setting after
a fixed period of time whenever no controls are used. Once a control on the unit or the
remote is pressed, the normal backlight level is restored.
Press Select and use the pq and the Select buttons to set the amount of time it will
take for the backlight to change to the dim level from 10, 20 ,30, 45, 60, 90, 120, or 180
seconds, or to keep the timeout feature Off.
On Level: Press Select and use the pq and Select buttons to choose the intensity of the
backlight.
Dim Level: If you selected a time for the backlight to change to a dim setting under
"Timeout", press Select and use the pq and Select buttons to choose the intensity of
the backlight when it changes to this dim setting. Setting the Dim level to "Off" may be
desirable if the display backlight is bothersome while sleeping. Using the Dim level
feature may also help to maximize battery playback time.
12 – ENGLISH