GE PDW1800 Serie Manuel Du Propriétaire page 13

Problem Possible Causes
Dishwasher won't run Fuse is blown, or the
circuit breaker tripped
Power is turned off
Reboot your control
Steam This is normal
Control panel Door latch may not be
responded to input properly seated
but dishwasher never
Water valve may be
filled with water
turned off
Dishwasher beeps This is normal
once every 15 seconds
This is a reminder that the
door has been left open
during operation
Beeping at the end This is normal
of the cycle
LOW RINSE AID Rinse aid dispenser
light is on needs to be refilled
What To Do
• Replace fuse or reset circuit breaker. Remove any other appliances
from the circuit.
• In some installations, the power to the dishwasher is proved through a
wall switch, often located next to the disposer switch. Make sure it is on.
• Turn off power to the dishwasher (at circuit breaker or wall switch) for
30 seconds, then turn back on.
• Steam comes through the vent during washing, drying and when
water is being pumped out.
• Make sure the door is firmly closed.
• Make sure water valve (usually located under the sink) is turned on.
• Close the door after opening it mid-cycle.
• Press ON/OFF to turn OFF the dishwasher.
• The dishwasher will beep and the CLEAN light will display at the end
of the wash cycle.
• This can only be turned off by filling the rinse aid dispenser with Jet-Dry
®
or Cascade Crystal Clear .
See Refilling the Rinse Aid Dispenser section.
ge.com
®
13