Installing Work Holding - Jet JWL-1221VS Mode D'emploi

You can now position the belt in the desired speed range.
"Low" speed range (60~900 rpm) for maximum torque.
"Medium" speed range (110~1800 rpm) for general use
"High" speed range (220 ~ 3600 rpm) for maximum speed.
Make sure belt is properly seated in both pulleys.
Push lever (G) down to tighten the belt.
Close and lock the pulley covers.

7.2 Installing work holding

Disconnect the machine from the power source (unplug).
The faceplate is used for tuning bowls. There are a number
of holes for mounting the workpiece.
Make sure the two sets screws (B, Fig 24) in the face plate
have been backed out.
Push in spindle lock (A)
Thread the faceplate onto the spindle in a clockwise direction,
and tighten.
Tighten the two set screws (B).
Fig 22
Fig 23
Remove the faceplate by loosening the two set screws (B).
Push in the spindle lock and use the provided tool (C).
Caution: always cut with your chisel on the left half of the
workpiece only.
Never press the spindle lock while the spindle is turning!
For reversing spindle rotation, always make sure face plate,
chuck or other is secured with the set screws. To avoid
threading loose.
The spur centre is used to hold workpieces between centres.
Make sure the mating surfaces are clean.
Push the spur centre into the spindle.
9
Fig 24
Fig 25