QSC AcousticDesign Serie Mode D'emploi page 3

Set the Transformer Tap Switch
Refer to — Figure 1
1. Insert a 4mm fl at-tip screwdriver into Transformer Tap hole
and engage the slot.
2. At fully clockwise the transformer is in 8-bypass.
AD-S10T
100 Volt 70 Volt
8 Ω 8 Ω
N/A 100W
100W 50W
50W 25W
25W 12.5W
— Table 1 —
AD-S6T, AD-S8T
100 Volt 70 Volt
8 Ω 8 Ω
N/A 60W
60W 30W
30W 15W
15W 7.5W
— Table 2 —
Mount the Loudspeakers
Install the Bracket
X-Mount™
Refer to — Figure 4
WARNING!: Install the system in accordance
with local building codes and regulations. Use
a licensed contractor or professional engineer.
QSC Audio Products is not responsible for
damages resulting from the negligent
installation of any bracket or loudspeaker.
1. Mount to a surface capable of supporting the weight of
the loudspeaker.
— Figure 2 —
— Figure 3 —
3
4mm
— Figure 1 —
— Figure 4 —
TD-000329-00-C
EN