Safety Instructions; General Safety Instructions; Scope Of The Documentation; Personnel Qualifications - Bwt Rondomat Duo-Dvgw 2 Instructions De Montage Et D'utilisation

EN

1 Safety Instructions

1.1 General safety instructions

The product has been manufactured according to the generally recog-
nised rules and standards of technology and complies with the legal re-
gulations in force when it was brought into circulation.
Nevertheless, there is still a risk of damage to persons or property if
you do not follow this chapter and the safety instructions in this docu-
mentation.
• Read this documentation thoroughly and in full before working with
the product.
• Retain the documentation in such a way that it is accessible to all
users at all times.
• Always hand over the product to third parties together with the full
documentation.
• Follow all of the instructions in relation to the proper handling of the
product.
• If you detect damage to the product or the mains supply, stop its
operation and notify a service technician immediately.
• Use only accessories, spare parts, and consumable materials that
have been approved by BWT.
• Maintain the environmental and operating conditions specified in the
"Technical data" chapter.
• Use your personal protective equipment. It ensures your safety and
protects you from injury.
• Only perform tasks that are described in these operating instructions
or if you have been trained to do so by BWT.
• Perform all tasks in compliance with all of the applicable standards
and provisions.
• Instruct the operator in the function and operation of the product.
• Instruct the operator in the maintenance of the product.
• Instruct the operator in relation to potential dangers that may arise
while operating the product.

1.2 Scope of the documentation

This documentation applies exclusively to the product whose
production number is listed on the title page and in chapter 12
"Technical data".
This documentation is intended for operators, end users, fitters without
training from BWT, fitters with training from BWT (e.g. drinking water
specialists), and BWT service technicians.
This documentation contains important information for fitting the pro-
duct safely and properly, starting up, operating, using, maintaining, and
disassembling the product, and for correcting simple faults internally.
Read this documentation in full before working with the product. Pay
particular attention to the safety instructions chapter.
28

1.3 Personnel qualifications

The installation work described in these instructions requires basic
knowledge of mechanics, hydraulics, and electrics, as well as know-
ledge of the corresponding specialist terms.
To ensure that the device is installed safely, this work must be performed
only by a qualified specialist or a trained person under the guidance of
a qualified specialist.
A qualified specialist is anyone who can assess the work assigned to
him or her, identify potential risks, and take suitable safety measures
thanks to his or her specialist training, knowledge, and experience as
well as his or her knowledge of the applicable regulations. A qualified
specialist must comply with the applicable specialist regulations.

1.4 Transport and installation

Whenever possible, transport the plant as a complete unit. If the plant
has to be dismantled for transport, check the completeness of the in-
dividual parts.
When there is a risk of frost, empty all water supply parts.
Always lift and transport the plant or plant parts only at the provided
transport eyes and/or attachment points.
The plant must be installed or mounted on a sufficiently stable and le-
vel vertical or horizontal base and sufficiently protected against falling
or overturning.

Symbols used

This symbol indicates general risks to persons, machi-
nes, or the environment.
This symbol indicates general risks due to the mains
voltage.
Risk of death by electric shock!
This symbol indicates information or instructions which
must be observed to ensure safe operation.
This symbol indicates information that is important to
follow.
Disconnect the mains plug before all service and re-
pair work.