OPERATING INSTRUCTIONS
This KOBE hood is equipped with four electronic controls with a 10-second standby startup &
30-second delay shutoff, two powerful centrifugal turbine impellers with safety screens, two
bright 12-volt 20-watt halogen lights, and four oil containers or baffle filters.
The four electronic controls are Light Control, Speed Control A (cycles through Low, Medium,
High, QuietMode™), Speed Control B (cycles through Low, QuietMode™, High, Medium) and
the Power Control (On/Off). Refer to Figure 30.
Light
Control
(Cycles through Low, Medium, High,
QuietMode™)
Turn On:
-
Press Power Control (On/Off) button once. (If any Control button is not pressed
within 10 seconds, power will be automatically turned off).
-
The KOBE hood will start on Low speed. Each press of the Speed Control button
will cycle through the various speeds.
-
Press Speed Control A button to cycle from Low, Medium, High, or QuietMode™.
Press Speed Control B button to cycle from Low, QuietMode™, High or Medium.
-
Press Light Control button to turn halogen light on.
Turn Off:
-
Press Power Control (On/Off) button once, panel lights will flash and power will be
completely shut off after 30 seconds.
OR
-
Press Power Control (On/Off) button twice, all power will be shut off immediately.
-
If only the lights are on, pressing Power Control (On/Off) button once will turn power
off after 30 seconds.
Speed Control A
Speed Control B
(Cycles through Low, QuietMode™, High,
Medium)
19
Figure 30
Power Control