Preparing The System - Cardin Elettronica S504 Serie Mise En Service Et Utilisation

433 MHz transmitters
TXQ504C2
TXQ504C4
TXQ504C8
TXQ504BD2
TXQ504BD4
TXQPRO504-4
TXQPRO504-4A
433 MHz receivers
RVQ504C1
RVQ508C4
Memory module ZGB24LC64-I/P
The module is furnished with a none-volatile EEPROM type memory and contains the transmitter codes and allows
you to memorise up to 1000 codes. The programmed codes remain stored even in the absence of power.
Attention! Removing and inserting the memory module must be carried out when the receiver is switched off
otherwise the memory content could become corrupt.

PREPARING THE SYSTEM

To obtain the best results from the radio control system the aerial installation site should be carefully chosen. 'Range'
is intended to mean the working distance, measured in free space, between the receiver and the transmitter with
the aerial installed. The range is therefore closely linked to the technical characteristics of the system and varies
according to the characteristics of the site in which the system is located. For best
to use the Cardin ANS400 / ANQ800-1 aerial. Wire the aerial to the receiver using a coaxial cable RG58
(impedance 50Ω) with a maximum length of 15 m.
868 MHz transmitters
TXQ508C2
TXQ508C4
TXQ508C8
TXQ508BD2
TXQ508BD4
TXQPRO508-4
TXQPRO508-4A
868 MHz receivers
RVQ508C1
RVQ508C4
11
Description
2-channel precoded transmitters
4-channel precoded transmitters
8-channel precoded transmitters
2-channel precoded transceivers
4-channel precoded transceivers
4-channel precoded industrial transmitters
4-channel precoded industrial transmitters + aerial
Description
1-channel receiver - 230V
4-channel outdoor receivers - 230V
performance we advise you