Specific Safety Warnings - Felisatti RS135/18L Manuel D'instructions

Specific Safety Warnings

Hold power tool by insulated gripping surfaces, when performing an
operation where the cutting accessory may contact hidden wiring.
Cutting accessory contacting a "live" wire may make exposed metal parts of the
power tool "live" and could give the operator an electric shock
Do not use the charger under the rain or when it is wet.
Failure to observe this can cause serious injury or death due to electric shock.
Do not insert metal wire or any conductive object through the ventilating
opening of the charger.
Failure to observe this can cause serious injury or death due to electric shock.
Do not attempt to disassemble the charger and keep the charger out of the
reach of children.
If the cord of the charger has been damaged, replace or repair it immediately.
Using the charger with damaged cord may cause electric shock.
Electric shock may cause injury.
Do not throw the battery into the live fire.
In the fire, the battery may explode due to high temperature and cause serious injury.
Do not short the terminals of the battery
If the terminals of the battery is short circuited, excessive current will flow and fire or
explosion may occur causing serious injury. When the battery is not used, store it after
mounting the protective cap firmly in place.
Avoid strong impact on the battery and do not pierce the battery case with a
sharp object.
Fire or explosion may occur causing serious injury.
Store the battery indoors at 0º~40º and avoid direct light and closed hot
and humid places.
Fire or explosion may occur causing serious injury.
Do not make your fingers and hands touch with the drill bit during operation.
When your fingers and hands are touched with the drill bit or caught in it, you may
be injured seriously.
Do not leave the running tool.
Other operators stayed close to you may be injured.
Set the forward/reverse lever in the neutral position while you are
changing or operating the tool.
Careless operating of the switch may cause a serious injury by the rotating part of
the tool.
Make sure the battery is attached in the body of the tool tightly before
you start operation.
When the battery is not attached tightly, it may be fallen during the operation and
cause an injury in the top of your foot.
6
All manuals and user guides at all-guides.com
2