Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Steps
Buff the top of the door trim with the scotch brite pad.
Then clean trim and surface where visor will mount
1
Peel back 2" (5cm) of tape liner from the front and rear flanges.
tape liner
rear end flange
3
With the visor in its final position, remove the remainder of the
tape liner by pulling on free ends.
5
The rear visor attaches to the door trim following the same procedure as the front visor. Refer to the correct figure for your particular ap-
figure 7a: Dodge
7
Intrepid
NOTE: Actual application may vary slightly from illustrations.
with an alcohol pad.
tape liner
front end flange
Apply one coat of surface prep to rubber trim. Prep rub-
ber trim on both sides before installing visors.
prep top of
trim
window
2
Align the driver side visor with previously cleaned door trim. Slide
the front end flange under the mirror cap. Rear and lateral flanges
attach directly to previously cleaned surfaces.
slide over
trim
visor
slide front end
4
flange under
mirror cap
Apply pressure along flange edges to ensure proper adhesion.
6
Repeat Steps 1-6 for passenger side.
plication.
figure 7b: Chrysler
LHS/New Yorker
Page 2 of 3
door trim
lateral flange
tape
free end
figure 7c: Eagle
Vision/Chrysler
Concorde
rear end
flange
Publicité
Table des Matières
